Manual for Configuring PAP2-NA

Installation and Troubleshooting GuideBasic Configuration of Linksys PAP2-NAPlug in the device and insert the RJ45 cable in the Ethernet port at the back of the device.Basic configuration of Linksys PAP2-NA using voice menu1) Attach a RJ11 cable to the phone port at the back of the Cisco ATA and connect another end to RJ11 port of the telephone instrument.2) Press the function key on top of the device and then key in the desired numbers as mentioned below for the settings you want to make. Interactive Voice Response Menu

Enter IVR Menu **** Use this command to enter the Interactive Voice Response Menu. Do not press any other keys until you hear, “Configuration menu. Please enter option followed by the # (pound) key or hang up to exit.”
Check DHCP 100 Use this command to find out if DHCP has been enabled or disabled.
Enable/Disable DHCP 101 Enter 1 to enable Enter 0 to disable
Check IP Address 110 You will hear the current IP address of the Phone Adapter.
Set Static IP Address 111 Enter the IP address using numbers on the telephone keypad. Use the * (star) key when entering a decimal point.
Check Network Mask 120 You will hear the current network mask of the Phone Adapter.
Set Network Mask 121 Enter the network mask using numbers on the telephone keypad. Use the * (star) key when entering a decimal point.
Check Gateway IP 130 You will hear the current gateway IP address of the Phone Adapter.
Set Gateway IP 131 Enter the IP address using numbers on the telephone keypad. Use the * (star) key when entering a decimal point.
Manual Reboot 732668 After you hear, “Option successful,” hang up the phone. The Phone Adapter will automatically reboot.

Using Linksys Web ManagerOnce you know the IP Address of Linksys PAP2, you are ready to log in to the unit through a Web browser. Open a new browser window and enter the PAP2’s IP address in the address box.
The PAP2 Web Manager appears.





Click on “Admin Login” as shown above to access admin rights





Then Click on System for network configurations, do the necessary changes as shown below, click on “Save Settings” after you finished configuring network.





Then click on Line1 to configure VoIP settings for Port 1 as shown below.





Then click on “Advanced view” to get full access.





Configure SIP Gateway, User ID and PIN as shown below.For incoming facility Setting configure the incoming no at Display Name and User ID field





For Billing Machine support set the reversal polarity as shown below




Now click on save settings and do the same for port 2 (Line 2)